personal expat service

Assembly of modules and machines based on customer specifications;
Fulfilling supply lead times and standard times;
Safe and certified operation of industrial equipment as needed;
Compliance with the health and safety, environmental regulations and standards as well as adhering to quality control regulations;
Participation in work discussion meetings;
Adherence to checklist and disassembly processes, including inspection, calibration and adjustment of the dynamic functions during test runs;
Initiation of improvements within one’s own area of responsibility. This includes identifying misalignment in protocol and resources, giving feedback on manufacturability and reproducibility of machines and com-municating any faults or deficiencies to the Team Leader. Collaboration with outside departments when needed;
Other tasks as specified by the Assembly Team Leader/Supervisor.

Perform administrative and coordination duties incl. reporting and technical escalations.
Contribute to the improvement loop of the EUV platform and processes.
Represent ASML at the customer site in a professional way incl. cultural awareness.
Qualification can take up to 6 weeks to complete.
Expected to travel 60 – 75% of the time to customers worldwide.
Expected to work inside the clean room, working with mechanical and electrical equipment.

Aligning the components of the HPSM and drive laser system after the commissioning phase.
Figuring out the cause of not meeting system specifications.
Monitoring and fine-tuning system components and settings (hardware, software, electronics, fluids and

Performing SAT measurements after the complete installation and final configuration.
Performing physical and performance tests, using a set of predefined test activities, developed to drive

Measuring and examining installed systems, using complex measuring equipment.
Checking main parameters, system settings and functionalities, using predefined acceptance test

Comparing the actual results with the expected results and evaluating the outcomes to determine if the

Providing confidence that the product meets both the functional and non-functional requirements.
Reporting progress or possible problems to Technical Coordinator or responsible office staff.
Maintain close communication to 3rd and 4th line support on advanced issues in case solving these

Coaching and instructing less experienced engineers on performing the same tasks.
Preparing the Drive Laser for customer handover under specific conditions.